home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Shareware Grab Bag
/
Shareware Grab Bag.iso
/
001
/
gt13001.arc
/
PURSUIT.DOC
< prev
next >
Wrap
Text File
|
1987-02-13
|
2KB
|
38 lines
Dear PC Pursuit User:
Well, a lot has been done to make GT more PC Pursuit compatible. First,
the Carrier Detect signal is no longer used to detect connect. The modem
result codes are now used exclusively. This enables ALL the dial routines
to work with PC Pursuit. Second, I have included a script for PC Pursuit
with the GT package. It allows you to connect with any city on the network,
then use the dialing routines of GT to connect with the BBS's. This provides
a very easy way to use PC Pursuit. I suggest that you modify the script, so
that your password and ID are included, instead of making you enter them
each time you run the script.
One gotcha tho, the modems on the network return "verbose" result codes.
Because of this you must change the "Modem Init String" to include a V1
instead of a V0, and you must also change the "Modem Result Codes" to
their verbal couterparts. This should not be too difficult to do, once
done it need not be redone.
One change to the config that would benefit PC Pursuit users is to erase the
Speaker-on and Speaker-off strings. These strings tend to confuse the city
modems on the network. After erasing these speaker control strings, place the
desired Mn command into your Modem Init String, or just let it default to the
switch settings of your modem.
Happy Networking!
Regards,
Paul Meiners
PS: The script PURSUIT.SCR is meant to be installed in your phone directory
as the logon script for the Telenet Access number. It is setup to use
Telenet and PC Pursuit in the 8-bit mode, DO NOT USE EVEN PARITY with
this script. If necessary you should change all of your 7-E entries
in your phone directory to 8-N, as far as PC Pursuit goes at any rate.